Percy the Ping-Pong Porter Version2

This is "Percy The Ping - Pong Porter" Version 2. The original Percy I built in 2007 was designed by Chris Shute the Instructions were originally published in Constructor Quarterly.

This later version was designed by Les Pattison and is loosely based on the original but with a completely different operating mechanism, only Percy is more or less the same and he seems to enjoy his new position. The original had great appeal of the original but I think this is even better and I found it easier to set up. The automaton (Percy) crouches down, picks up a ping-pong ball that drops into his arms from the bottom rails,  moves up and sideways on a skate board dropping it on the top rails, before descending and sliding back starting the sequence over again. I have no need to say much about the details and the construction of the model as full building instructions can be downloaded here .

The model was a big hit when I recently exhibited it at the Museum of Powere at langford near Maldon. The anticipation that Percy might drop a ball adds to his appeal especially when ran very slowly but he ran for hours missing very few balls. This in fact was caused by him not being level so I added two adjustable feet to lift him up a few millimeters.

Percy the Ping Pong Porter is built mainly from zinc and 1970s Binns Road yellow parts and four green brackets as i did not have sufficent available at the time of building.

April 30 2008

Back to Gallery of Meccano Models.