Solo new build project : TOOTSWEET
... from FRP shell and kit supplied by Tony Thresher. [start here] or select picture from list below.
 
Shell as supplied with cross beam braces and base of gunwhale, set up and levelled on tressles:
[shell 1] [shell 2] [shell 3] [shell 4] [shell 5]
Forward bulkhead fitted & sidedeck knees filleted in place:
[knees 1] [bulkhead 1] [knees 2] [bulkhead 2]
Sidetanks with butt joins to aft section:
[port (looking aft)] [butt end] [butt join] [starboard aft section]
Stem backing, deck beam, kingplank & strut, starting to shape bulkhead & beam:
[kingplank & strut] [deck beam & stem back] [tiller port etc.] [deck line now cut]
Bracing beams removed:
[wedge @ station #4] [deck supports in] [& shroud plate backing]  
Fitting foreward deck sections: (that's what you do with 60 paper clips and a Skua lead bulb!)
[port side fore section] [port foredeck] [starboard fore section] [starboard foredeck]
Fitting aft deck sections:
[port side glued] [starboard clipped] [ready for trimming!] [thwart held in place]
Trimmed for gunwhales, transom & CB case capped, thwart & port gunwhale glued:
[transom capped] [thwart now glued!] [port gunwhale] [& from forward]
Sep 2006 - project resumed!!
Off the building frames, starboard gunwhale & extended gunwhale (screws still in):
[gunwhale (bow) ] [gunwhale (stern) ] [extended gunwhale] [& from forward]