Instructions

Make sure that ALL Volumes are turned to ZERO before turning on any of the equipment (The two amp volume knobs are located at the rear of the amp on the left hand side). Plug all mains leads into mains sockets. 

1. Using the supplied "numbered and colour coded leads", connect as shown in the diagram above. *(The equipment will not function correctly if connected any other way).* 

Ensure that ALL connections are made before turning on equipment.

It is now safe to turn the equipment on, after which the volumes can be turned up on the amp, and the system can now be tested. 

Should you experience any problems there is a troubleshooting section on our website:

http://www.musiccompany.co.uk/troubleshooting.htm

Back To Home Page