|
Instructions
1. Make sure that all volumes are set to ZERO.
2. Connect the output of the mixer to the cross over inputs of the CS1200 Amplifier, marked
RED & BLUE
3. There should be a lead going from the Crossover Low outputs, marked in
GREEN to either of the CS1200 Inputs Ch A & B, marked
BLACK. this feeds the low frequency signal back into the CS1200.
4. This amp is the amp that feeds the Bass bins.
5. Connect the CS1200 Outputs to the bass bins.
6. Connect the Cross over high outs, marked BROWN into the inputs of AMP 2 marked
MAUVE.
7. Connect the speaker outs from AMP 2 to the top cabs.
8. Turn the equipment on, and set the volumes for each amp accordingly, remembering that the CS1200 is only delivering Bass, and the other amp is limited to the higher frequencies only.
*The colours on this diagram are for explanatory purposes only. The equipment itself is not colour coded*
|
